Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:guides:boottime [2010/05/30 13:59] linea |
en:guides:boottime [2010/08/22 23:06] linea |
||
---|---|---|---|
Line 2: | Line 2: | ||
SliTaz boots fast! But most likely you haven't turned super fast boot on yet. To do this, just edit your ///etc/rcS.conf// : | SliTaz boots fast! But most likely you haven't turned super fast boot on yet. To do this, just edit your ///etc/rcS.conf// : | ||
- | <code> FAST_BOOT_X="yes" </code> | + | <file> FAST_BOOT_X="yes" </file> |
Remove dbus, hald and slim from the RUN_DAEMONS array. That's all. Note, on some machines, FAST_BOOT_X may not boot properly. However, if Xvesa/Xorg works after you enable this feature, it's safe to leave it on. | Remove dbus, hald and slim from the RUN_DAEMONS array. That's all. Note, on some machines, FAST_BOOT_X may not boot properly. However, if Xvesa/Xorg works after you enable this feature, it's safe to leave it on. | ||
Line 10: | Line 10: | ||
But, how do you graph your full boot process (including the kernel-boot time)? Its quite easy on SliTaz. Just do and install the following: | But, how do you graph your full boot process (including the kernel-boot time)? Its quite easy on SliTaz. Just do and install the following: | ||
- | <code> tazpkg get-install pybootchartgui </code> | + | <code> # tazpkg get-install pybootchartgui </code> |
Pybootchartgui will then create a chart automatically in ///var/log//. | Pybootchartgui will then create a chart automatically in ///var/log//. | ||
- | Now, just edit your menu.lst file for grub and add init=/sbin/bootchartd. In my case, it's like this: | + | Now, just edit your //menu.lst// file for grub and add init=/sbin/bootchartd. In my case, it's like this: |
- | <code> | + | <file> |
title slitaz with bootchart | title slitaz with bootchart | ||
root (hd0,8) | root (hd0,8) | ||
kernel /boot/vmlinuz-2.6.30.6-slitaz root=/dev/sda9 init=/sbin/bootchartd quiet | kernel /boot/vmlinuz-2.6.30.6-slitaz root=/dev/sda9 init=/sbin/bootchartd quiet | ||
- | + | </file> | |
- | </code> | + | |
Here's my boot chart with WPA2 wifi (under 10 secs boot time on a laptop with hard disk). This is out-of-the-box!!!: | Here's my boot chart with WPA2 wifi (under 10 secs boot time on a laptop with hard disk). This is out-of-the-box!!!: |