Differences

This shows you the differences between two versions of the page.

--- en:guides:poulsbo [2012/05/13 21:28]
o created
+++ en:guides:poulsbo [2015/04/04 12:40] (current)
linea
@@ Line 1: / Line 1: @@
 ====== Poulsbo (aka GMA500) ======
-This is a short guide on getting the Poulsbo graphics working nicely with SliTaz.
+This is a short guide on getting the Poulsbo graphics working nicely with SliTaz 4.0 or new rolling-core
-Start by booting the 4.0 version of SliTaz with a working network connection. Run the installer and when asked for source pick Web and paste the following url.
-<file>http://mirror.slitaz.org/iso/rolling/slitaz-rolling.iso</file>
-After a successful installation you will need to do the following steps to get the graphics working.
+Boot SliTaz and establish a working network connection.
+After a successful installation you will need to do the following steps to get the graphics working:
 <code># nano /etc/rcS.conf</code>
 Look for the row called LOAD_MODULES and remove poulsbo from the list, also make sure that psb_gfx is present.
-Then remove VESA and add the psb_gfx module (which is inside the linux-staging package)
+Then remove VESA and add the psb_gfx module (which is inside the linux-staging package):
 <code># tazpkg remove xorg-xf86-video-vesa
+# tazpkg recharge
 # tazpkg get-install linux-staging</code>
+The fbdev-driver needs to be installed/updated:
+<code># tazpkg -gi xorg-xf86-video-fbdev</code>
+Simply reboot and the graphics should work nicely with the correct resolution.

en/guides/poulsbo.1336937305.txt.gz · Last modified: 2012/05/13 21:28 by o

SliTaz Doc