SliTaz GNU/Linux official and community documentation wiki.
.png
Translations of this page:

This is an old revision of the document!


Poulsbo (aka GMA500)

This is a short guide on getting the Poulsbo graphics working nicely with SliTaz.

Start by booting the 4.0 version of SliTaz with a working network connection. Run the installer and when asked for source pick Web and paste the following url:

http://mirror.slitaz.org/iso/rolling/slitaz-rolling.iso

After a successful installation you will need to do the following steps to get the graphics working.

# nano /etc/rcS.conf

Look for the row called LOAD_MODULES and remove poulsbo from the list, also make sure that psb_gfx is present.

Then remove VESA and add the psb_gfx module (which is inside the linux-staging package):

# tazpkg remove xorg-xf86-video-vesa 
# tazpkg get-install linux-staging

The fbdev-driver also needs to be installed (to replace VESA):

# wget http://cook.slitaz.org/cooker.cgi?download=xorg-xf86-video-fbdev-0.4.2.tazpkg
# tazpkg install xorg-xf86-video-fbdev-0.4.2.tazpkg

Simply reboot and the graphics should work nicely with the correct resolution.

 
en/guides/poulsbo.1336937448.txt.gz · Last modified: 2012/05/13 21:30 by o