This is an old revision of the document!
Poulsbo (aka GMA500)
This is a short guide on getting the Poulsbo graphics working nicely with SliTaz.
Start by booting the 4.0 version of SliTaz with a working network connection. Run the installer and when asked for source pick Web and paste the following url:
http://mirror.slitaz.org/iso/rolling/slitaz-rolling.iso
After a successful installation you will need to do the following steps to get the graphics working.
# nano /etc/rcS.conf
Look for the row called LOAD_MODULES and remove poulsbo from the list, also make sure that psb_gfx is present.
Then remove VESA and add the psb_gfx module (which is inside the linux-staging package):
# tazpkg remove xorg-xf86-video-vesa # tazpkg get-install linux-staging
The fbdev-driver also needs to be installed (to replace VESA):
# wget http://cook.slitaz.org/cooker.cgi?download=xorg-xf86-video-fbdev-0.4.2.tazpkg # tazpkg install xorg-xf86-video-fbdev-0.4.2.tazpkg
Simply reboot and the graphics should work nicely with the correct resolution.