SliTaz GNU/Linux official and community documentation wiki.
.png

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Last revision Both sides next revision
en:guides:wicd [2010/08/17 20:37]
kultex created
en:guides:wicd [2010/08/17 22:45]
linea
Line 1: Line 1:
 ====== WICD ====== ====== WICD ======
  
-[[http://​doc.slitaz.org/​en:​guides:​network-script|Panksos ​openbox treat]] is very near to WICD, but if you set up SliTaz for not experienced users its recommanded to use WICD for Wireless Internet Control+[[http://​doc.slitaz.org/​en:​guides:​network-script|Pankso'​s ​openbox treat]] is very close to WICD, but if you want to set up SliTaz for not very experienced users it's recommended that you use WICD for Wireless Internet Control.
  
-do as root:+Do as root:
  
 <​code>#​ tazpkg get-install wicd <​code>#​ tazpkg get-install wicd
 # leafpad /​etc/​rcS.conf</​code>​ # leafpad /​etc/​rcS.conf</​code>​
  
-In /​etc/​rcS.conf remove ​in the section RUN_SCRIPTS network.sh +In ///​etc/​rcS.conf// remove ​from the section RUN_SCRIPTSnetwork.sh 
-and add in the section RUN_DAEMONS wicd+and add to the section RUN_DAEMONSwicd
  
-than as user:+Then as user:
  
 <​code>​$ leafpad .config/​openbox/​autostart.sh</​code>​ <​code>​$ leafpad .config/​openbox/​autostart.sh</​code>​
-add on the end:+And add to the end:
  
-<code># wicd Network Configuration +<file># wicd Network Configuration 
-wicd-client &</code>+wicd-client &</file>
  
-and remove the network-plugin from the LX-Panel by right cklicking ​on the network-plugin ​+Then remove the network-plugin from the LX-Panel by right clicking ​on the network-plugin
  
-reboot ​dont test before rebooting, because network.sh is interfering with WICDeven you stop it by typing /​etc/​int.d/​network.sh stop+Reboot ​don'​t ​test before rebooting, because network.sh is interfering with WICD (even you stop it by typing /​etc/​int.d/​network.sh stop).
 
en/guides/wicd.txt · Last modified: 2010/08/21 19:55 by linea