This is a short guide on getting the Poulsbo graphics working nicely with SliTaz 4.0 or new rolling-core
Boot SliTaz and establish a working network connection. After a successful installation you will need to do the following steps to get the graphics working:
# nano /etc/rcS.conf
Look for the row called LOAD_MODULES and remove poulsbo from the list, also make sure that psb_gfx is present.
Then remove VESA and add the psb_gfx module (which is inside the linux-staging package):
# tazpkg remove xorg-xf86-video-vesa # tazpkg recharge # tazpkg get-install linux-staging
The fbdev-driver needs to be installed/updated:
# tazpkg -gi xorg-xf86-video-fbdev
Simply reboot and the graphics should work nicely with the correct resolution.